![]() ![]() Slowly lower the glass again, and the screen should be reset. Then raise the glass all the way to the top. To reset the screen into the sides, slowly lower the glass all the way to the bottom. The screen is designed to blow out in heavy winds or when pushed on to prevent damage to the screen. How can I adjust my Screen Away® screen so that it doesn’t blow out or push out on the sides?.Polish the brass using a brass cleaning product, according to package instructions. Unprotected brass will tarnish under this exposure. Over time, the clear coat finish can wear through or be compromised by nicks from rings and keys, exposing the solid brass to the elements. These handle sets have a clear coat finish to protect the brass. Remove the handles and confirm that the narrow end of the spring is inserted into the outside handle, and the wide end is against the door. Or the spring may be installed backwards. There may be too much tension in the handle screws try loosening them. Why does the button stick on my push button handle?.If there is not lipstick on the strike plate, but there is a mark on the back surface of the deadbolt hole, the deadbolt hole in the door frame needs to be deepened with a chisel. Wipe the plate clean, and repeat the test until the deadbolt engages freely and doesn’t leave a mark. Open the door, and if there is a lipstick mark on the latch rail or strike plate, adjust as needed. When the door is closed, engage the deadbolt all the way. To determine in which direction and how much to move it, apply some lipstick to the edge of the deadbolt. Adjust the strike plate to allow the deadbolt to move freely. If the handle set and deadbolt move freely when the door is open, the deadbolt may be hitting the edge of the strike plate. If either does not operate when the door is open, the hardware needs to be replaced. Once the door is open, operate the handle and turn the deadbolt. This will loosen the tension on the deadbolt allowing it to retract and the door to open. To unjam the deadbolt, remove the latch side rail installation screws. The storm door deadbolt and latch side rail are likely misaligned, which can prevent the deadbolt from retracting. What can I do if my deadbolt is stuck or not working?. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |